Setup
The figure below illustrates the minimal setup you need to run the sample applications from the Cookbook.
- You will not modify the firmware on the
SmartMesh manager
. - You will reprogram the
SmartMesh mote
with the different sample applications, using IAR and the j-link programmer. - On the computer, we recommend you start the following applications:
- A serial terminal connected to the CLI port of your
SmartMesh manager
. - A serial terminal connected to the CLI port of your
SmartMesh mote
. - IAR Embedded Workbench for ARM.
- Optionally, the
ApiExplorer
application of theSmartMesh SDK
, connected to the API port of theSmartMesh manager
.
- A serial terminal connected to the CLI port of your
Refer to the SmartMesh IP Tools Guide for information about the different serial ports corresponding to each device.