Setup

Image RemovedImage Added

It connects to:

•  The SmartMesh IP Manager
•  (Over the air) The SmartMesh IP Mote running in master mode  - this is the default mode for motes in an evaluation kit.

...

• The manager connection frame allows you to connect to the SmartMesh IP manager.
• The LED ping frame allows you to select the SmartMesh IP mote of interest, and monitor its LED state.
• The Notes frame contains some help information.

 

Image Removed

Image Added

Description

The default firmware of the SmartMesh IP Mote implements the On-chip Application Protocol (OAP). The LEDPing application connects to the SmartMesh IP Manager and sends OAP packets to any SmartMesh IP Mote in the network, to continuously toggle its INDICATOR LED. That is, after pressing the start button:

...

• Start the LEDPing application:
  Image RemovedImage Added

• Connect the application to your manager, either through the SerialMux, or directly over the serial port. The fields in the manager connection frame turn green, indicating a successful connection.
  Image RemovedImage Added

• Enter the full MAC address of any mote currently in operational mode in the network. Press the start button.

• The LEDPing application will blink blue at the same time as the LED on the mote.

  Image RemovedImage Added

  Image RemovedImage Added

• At any time, click the stop button to interrupt the blinking.
  Image RemovedImage Added