Expected completion time of this lab:
. |
This step enables the GPIO input pin. It is a required step for reading its value or activating notifications.
The D0 GPIO corresponds to the |
create a flow which issues:
with payload
{
sampleCount: 1,
rate: 10000,
enable: 1,
dataFormat: 0
} |
Open the SmartMesh IP Tools Guide (http://www.linear.com/docs/42453), looks for section "/digital_in". What does dataFormat 0 mean?
create a flow which issues:
What is the state (value) of your pin?
Connect a jumper between the DP2 and VSUPPLY pins. Make sure you can read the value of digital_in/D0 to be high.
Connect a jumper between the DP2 and GND pins. Make sure you can read the value of digital_in/D0 to be low.
NEVER CONNECT |