SimplePublish for SAM C21 Xplained Pro

The QSL includes a SimplePublish example for the Atmel SAM C21 Xplained Pro evaluation kit. This is an Atmel Studio 7 project based on the Atmel Software Framework (ASF). The main.c code itself is similar to the one for RPi, with the addition of a watchdog timer and initialization of a second serial port to enable debug prints (the watchdog is for demonstration purposes only, and can be removed as the user see fit).

Although the code is written specifically for the ATSAMC21J18A on the SAM C21 Xplained Pro evaluation kit, it should be pretty straightforward to port it to similar architectures since ASF is used. Correctly configuring the available serial ports (SERCOM) in serial.c/.h should be the only thing that might require some adaptation.

Prepare Atmel Studio

Download and run the Atmel Studio web installer from the official download page, and follow the instructions. This will also install the necessary drivers for the embedded debugger on the Xplained Pro board.

Prepare the SAM C21 Xplained Pro

Set Supply Voltage to 3.3 V

Make sure that the jumper on the 3-pin header labeled VCC_SEL is set to 3.3 V, as seen in Figure 1. This will select 3.3 V as the supply voltage for the ATSAMC21J18A, peripherals and extension headers, which is important as we will power the mote from the latter.

Figure 1: Xplained Pro VCC selection header.

Connect to Mote

Figure 2: Mote connected to the SAM C21 Xplained Pro.

The Xplained Pro has three extension headers (EXT1, EXT2, EXT3) with pins as listed in Table 1: Connect to the mote as per the mapping in Table 2. In Figure 2 you can see the mote connected to EXT1, but it does not matter which one you use: The pins for UART RX/TX are all connected to the same pins on the SAM C21.