Figure 3: The DC2274A SmartMesh IP USB Manager
...
Similar to the mote via the interface board, you should now see 4 new serial ports, where the third and fourth give you access to the CLI and API, respectively.
...
Factory Default Values
By default the manager is shipped with a well-known network ID and join key that your application will need to connect to its network, so you do not need to configure anything. However, it is useful to know about certain commands available through the CLI. These commands are presented in the next section, while relevant default values for its configuration parameters are listed in Table 4.
...
Refer to the SmartMesh IP User's Guide for a complete list of default configuration parameters for the manager.
...
...
Useful CLI Commands
With the manager connected to your computer via USB:
...